Install The Print Ribbon - Rimage Everest 600 Guia Del Usuario

Maintaining the Everest 600 Printer

Install the Print Ribbon

1. Remove the new print ribbon from the packaging.
2. Install the print ribbon on the print ribbon carrier.
a. With the supply roll on the left side, unwind several inches of the
print ribbon.
Tacky Roller
Supply Roll
b. Lay the print ribbon across the tacky roller and guide rollers.
c. Install the supply roll as shown.
d. Install the take-up roll as shown.
2001474_B
Guide Rollers
Take-up Roll
Important:
•
•
3. Reassemble the printer.
Tip: Ribbon color can vary from lot to lot. After you load the new ribbon, you
may need to adjust the density settings in the printer driver. Refer to the
Adjust the Print Alignment and Color Density (PC)
the
page 15 for more information.
The printer is ready for use.
For more information visit rimage.com/support
e. Rotate the take-up roll clockwise so the ribbon is aligned and lies
flat. You may need to lift the ribbon up from the tacky roller to
straighten it.
Do not rotate the ribbon past the Cleaning Bars at the front of the
ribbon .
If you installed a monocolor ribbon, advance the ribbon so the ink
portion of the ribbon is advanced to the take-up roll.
a. Set the print ribbon carrier upright.
b. Slide the print ribbon carrier into the printer.
c. Close latch 1.
d. Close the side cover.
Adjust the Print Alignment and Color Density (Macintosh)
Take-up Roll
section on page 13 or
section on
19