Rimage Everest 600 Guia Del Usuario página 30

Maintaining the Everest 600 Printer
f. Turn the mode switch to the correct operating position.
For more information, refer to the
g. Power on the printer.
The printer is ready for use.
Clean the Sensors
When should you clean the sensors?
• You receive an error message stating that the printer is not detecting the
print ribbon.
• You receive an error message stating that the upper sensor is not
responding.
• You receive an error message stating that the lower sensor is not
responding.
• The printing is off center.
Tools Required
#
• Sponge swabs with long
handles (included in the
Everest cleaning kit)
• Can of compressed air
1. Access the sensors.
a. Press the two side cover
latches to release the side
cover.
b. Lower the side cover.
c. Open latch 1.
d. Remove the print ribbon carrier. For specific instructions, refer to
Remove the Print Ribbon
the
2001474_B
Switches section on page 9.
procedure on page 17.
For more information visit
e. Remove the retransfer ribbon carrier. For specific instructions, refer
to the Remove the Retransfer Ribbon
2. Power off the printer, autoloader or AutoPrinter. Refer to the
and Off the Everest 600 Printer
Important! Do not clean the printer sensors until the printer is
completely powered off.
3. Locate the sensors.
• Print ribbon sensor
• Upper sensor
• Lower sensor
Print
Ribbon
Sensor
rimage.com/support
procedure on page 20.
Power On
section on page 10 for instructions.
Upper
Sensor
Lower
Sensor
27