Clean The Rear Air Filter - Rimage Everest 600 Guia Del Usuario

Maintaining the Everest 600 Printer
2. Clean tacky roller 1 (on the print ribbon carrier).
a. Apply isopropyl alcohol to the sponge swab.
b. Use the sponge swab to clean tacky roller 1.
c. Use the sponge swab to remove any waxy buildup from other parts
of the ribbon carrier.
d. Install the print ribbon on the print ribbon carrier. Refer to the
Change the Print Ribbon
3. Inside the printer, use the sponge swab to wipe tacky roller 2.
4. Prepare the printer for use.
a. Install the print ribbon carrier.
b. Close all latches.
c. Close the side cover.
The printer is ready for use.
2001474_B
procedure on page 17.
Tacky
Roller 2
For more information visit

Clean the Rear Air Filter

Tool Required: Phillips #2 screwdriver
#
1. Remove the air filter.
Fan Cover
a. At the rear of the printer, remove the Phillips screws (Qty. 2) that
secure the fan cover.
b. Remove the fan cover.
c. Remove the air filter.
2. Clean the air filter.
a. Hold the air filter under running water.
b. Allow the air filter to dry.
3. Prepare the printer for use.
a. When the air filter is dry, place it inside the fan cover.
b. Insert the screws (Qty. 2) to secure the fan cover to the back of the
printer.
The printer is ready for use.
rimage.com/support
Air Filter
Screws
23