Power Off - Sonic Impact Technologies i-F2 Guía De Usuario

4. Put the remote back to the compartment after using to avoid any loss

POWER OFF

All manuals and user guides at all-guides.com
When not in use and to minimize power consumption, please set the power switch to the "OFF"
position . Please note that the i-F2 has an "AUTO SHUT-DOWN (STANDBY) function which
prevents excess power consumption during idle play.
AUTO SHUT-DOWN (STANDBY):
When the power switch is set at the "AUTO ON"position, the i-F2 system will shut down automatically
and goes into standby mode if an audio signal is not detected within
switch will then turn to red The LED will automatically turn to green
audio signal is detected and the i-F2 system will automatically power on. Power consumption will be
reduced in this "standby" mode, but we suggest that you shut down the i-F2 system completely when
not in use for an extended period of time to save battery life.
DATA TRANSFER
DATA TRANSFER:
Note that you can download and upload music while your iPod is docked in the i-F2's docking station,
using the iPod Dock Connector to Fire Wire Cable that came with your iPod. Simply plug that cable into
the port located on the left side of the i-F2, and plug the other end into your computer. Follow the
instructions that were included with your iPod to download, upload, and manage your music
BUILT-IN LITHIUM BATTERIES
1. The i-F2 system uses a rechargeable built-in 8.4V @2000mAH Lithium ion battery.
2. A. Prior to your first use of the i-F2 powered off of the Lithium ion battery, you must fully charge
the battery. Plug in the 9V@2.0A AC into an AC wall outlet and insert the barrel connector at the
end of the adapter cable into the socket marked
full charge will take 6-8 hours.
B. To recharge, connect the AC power adapter as described above. A full recharge will take 4-6
hours. With the iPod docked, both the battery and the iPod will be recharged simultaneously,
3. The i-F2 system has a row of LED lights that serve as battery life indicators.
high power
slight power
4. The i-F2 system has a low power warning function. When the "charge required" indicator turns red,
it is a warning that the system will soon go into the SHUT-DOWN mode. The system will operate
again after power has been charged and the unit is turned back on.
5. While the i-F2 system is being charged, the power indicator lights will blink in sequence until the
last light at the right end stops blinking. The charging is now completed.
F2 Lithium battery can last 8 hours
5 minutes. The LED on the power
on the side of i-F2 system. A first time
moderate power
WARNING: charge required:
Under normal use, the i-
when an