PULOX PO-100 Manual De Instrucciones página 27

 Clinical function: calculate SpO2 and pulse rate values by collecting and
processing the testee's pulse signal.
5. Operating Guide
1) Insert the two batteries properly to the direction, and then replace the
cover.
2) Open the clip as shown in Figure 5.
3) Let the patient put his finger into the rubber cushions of the clip (make
sure the finger is in the right position), and then clip the finger.
4) Press the button once on front panel.
5) Do not shake the finger and keep the patient at ease during the process.
Meanwhile, human body is not recommended in movement status.
6) Get the information directly from screen display.
Fingernails and the luminescent tube should be on the same side.
6. Cleaning, Transport and Storage
6.1 Cleaning and Disinfecting
The device must be turned off before cleaning, and it should not be
immersed into liquid.
Please take out the internal battery before cleaning, do not immerse it into
liquid.
Use 75% alcohol to wipe the device enclosure, and use liquid soap or
isopropanol to wipe the watchband for disinfection, nature dry or clean it
with clean and soft cloth. Do not spray any liquid on the device directly, and
avoid liquid penetrating into the device.
6.2 Maintenance
A. Check the main unit and all accessories periodically to make sure that
there is no visible damage that may affect patient's safety and monitoring
performance. It is recommended that the device should be inspected weekly
at least. When there is obvious damage, stop using it.
Figure 5 Finger Position
EN