Apply
sealant
12. Install the Offset Pile Seal, Threshold Insert and Apply Silicone Sealant
- Measure the distance between the hinge and the side panel or strike jamb edge.
- Cut the offset pile seal and threshold insert to the measured distance.
- Position the pile seal so the pile side is towards the inside of the shower.
- Apply three dabs of silicone sealant into the groove on the threshold and insert the threshold insert into the
groove.
- Apply silicone sealant to the outside of the shower where it meets the walls.
A
1015287-2-
Offset Pile Seal
Apply
sealant
Threshold Insert
12
Header
Threshold
Kohler Co.