SEVERIN Hair Care HS 0771 Manual Del Usuario página 12

and 7 mm.
Operation
 Before each use, always put a few drops
of acid-free oil between the trimming comb
and the blade.
Cutting hair:
– Fit the hair trimming-head.
– For longer hair, one of the push-on combs
provided may be used. We recommend that
you start with the large comb.
– Switch the appliance on.
– The hair should fi rst be combed, and then
generally cut against its natural direction.
– Always cut from bottom to top with the
shaving head lying against the head; lead
the appliance upwards through the hair,
moving it gradually away from the head at
the same time
– For a shaped cut, reverse the appliance and
shorten the hair from top to bottom without
a push-on comb.
Trimming the beard:
– Fit the beard/contour trimming-head.
– For longer beards, the small push-on comb
attachments should be used. However,
always start with the largest cutting-length
setting.
– Switch the appliance on.
– The beard is generally cut against the
natural direction of growth.
– Always begin at the neck and move the
appliance upwards through the beard hair.
– For a shaped cut, reverse the appliance and
shorten the hair from top to bottom without
using the push-on comb.
Care and Cleaning
 It is essential to switch off the appliance
and then remove the adaptor from the wall
socket before cleaning and oiling. To avoid
the risk of electric shock, the appliance
and the adaptor must not be immersed in
liquid or allowed to come into any contact
with liquid.
– If necessary, the exterior surfaces of the
appliance, its charging base and adaptor
may be wiped with a dry, lint-free cloth.
Trimming comb and trimming blade
– After each use, use the cleaning brush to
remove hair from between the trimming
comb and the blade.
– Caution: The trimming comb and blade
are very sharp.
– Before use, and again after every 15
minutes' operation, put a few drops of
acid-free oil between the trimming comb
and the trimming blade and then switch
the appliance on briefl y to ensure that the
oil is evenly distributed. Regular oiling will
guarantee good cutting performance over a
long period and a long service life.
Battery pack disposal
 This appliance contains a nickel-metal
hydride (Ni-MH) rechargeable battery pack,
which must be removed for disposal. To
remove, fi rst disconnect the appliance
from the mains. Use a small screwdriver
to remove the two screws on the lower
housing and take the lower part off. Use
a suitably strong object to push the motor
and battery pack assembly upwards and
lift it out. Take out the battery pack and
carefully cut the connecting wires coming
from the battery pack one by one. Ensure
that the battery pack is not short-circuited
by mistake.
'special garbage collection points'.
12
Do not dispose of the
rechargeable Ni-MH
battery pack in your
domestic garbage. All
batteries must be disposed
of through the proper local