Remote Control Procedures - Emerson CF930LBS00 Manual Del Propietário

7.1: Preset Memory Feature
Your Emerson receiver is equipped with a preset
memory feature. If the AC supply to the receiver is
powered through a wall switch, when the switch is
turned OFF, the control will remember the light intensity
and fan speed.
7.3: Setting Operating
Frequency of Remote Control
Remove the Battery Cover by pressing firmly below
the arrow and sliding the Cover off the Control
(Figure 35).
Your Remote Control has Code Switches which must
be set in one of 32 possible code combinations.
The five levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up) position.
Change the Switch settings as follows:
Slide the five Switch Levers in the Remote Control to
your choice of ON (up) or down positions. Use a ball-
point pen or small screwdriver and slide the Levers
firmly up or down (Figure 35).
The sixth Switch marked ON and I is for dimming
control of lights: Set Switch to ON to allow for dimming
of the lights. Set Switch to I for no dimming of the lights
such as for fluorescent bulbs.

7. Remote Control Procedures

When the switch is turned back ON the light and fan
will resume operation as they we re prior to the switch
being turned OFF.
Figure 34
BATTERY
COMPARTMENT
COVER
Figure 35
NOTE: If your Fan and Light go on and off without
using your Control, you may be getting interference
from other remote units such as garage door
openers, car alarms or security systems.
To remedy this situations, simply change the
combination code in your Remote Control Transmitter.
20
REMOTE CONTROL
LEVERS
ON
1 2 3 4 5 I
CODE
SWITCHES
REMOTE CONTROL
U.L. Model No.: CF930L