Warranty - Youin Amsterdam BK1000 Manual De Instrucciones

Problems and Remedy
Bicycle operates OK but
battery gauge does not light up
Battery gauge lights up but
bicycle does not operate
Bicycle runs at full speed without
pedaling
Battery indicates full charge
when tested at the charge port
but bicycle does not operate
Throttle (on bicycle so equipped)
does not sring back to neutral
position
Bicycle has intermittent power
Charge shows a full charge in an
Unusually short amount of time
Indicator light on charger not
Illuminated when charger is
plugged into outlet
Charger(Lithium) indicator light
only flashes red and never
changes to green
Use approved replacement parts, particularly for safety critical components.
Consult with your dealer as needed.

Warranty

Carefully read all instructions before using the electric kick scooter.
This product is warranted according to the local laws.
The warranty shall not apply to any products that have been subjected to misuse,
negligence, accidental or abnormal conditions of operation, and does not covers the
natural capacity fade out.
Please refer to qualified and authorized people for the repair of the electric kick scooter.
A non-professional repair may cause malfunction and risks and void your warranty rights.
- Loose connectors
- Damaged wires
- Faulty battery gauge
- Faulty brake inhibitor
- Loose motor wire connector
- Faulty sensor
- Faulty throttle
- Faulty controller
- Faulty controller
- Loose connectors
- Poor contact between battery
terminals
- Grip jammed against throttle
- Faulty throttle
- Loose connectors
- Damaged wires
- Faulty charger
- Faulty batteries
- Outlet has no power
- Faulty charger
- Damage wire from charger port
to battery
- Faulty batteries
- Check throttle and/or battery
gauge connectors
- Inspect all wires
- Replace battery gauge
- Replace brake inhibitor(s) and
retest
- Check motor wire connector
- Replace sensor and retest
- Replace throttle and retest
- Replace controller and retest
- Replace controller
- Check all connectors
- Inspect and clean battery
terminals
- Reposition grip so gap between it
and the throttle is 1-2mm
- Replace throttle
- Check all connectors
- Inspect all wires
- Replace charger
- Replace batteries
- Check outlet for power
- Replace charger
- Inspect wire
- Replace batteries
ENGLISH 25