Worx WX653 Manual Del Usuario página 8

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Double insulation
Wear eye protection
Wear ear protection
Wear dust mask
8
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
Random orbital sander
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for dry sanding of
wood, plastic, metal and filler material as well
as painted surfaces. Machines with electronic
control are also suitable for polishing.
ASSEMBLY THE ROTARY
SANDER
1. REPLACING THE SANDING PLATE
(See Fig. A)
To replace the sanding plate, pull off the Sand
paper. Loosen and remove the screw.
Replace damaged sanding plates without
delay.
2. REPLACING THE SAND PAPER
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
A) Selecting the sand paper
Depending on the material to be worked and
the desired material removal, various Sand
paper qualities are to be used:
- Use coarse grits to sand down rough finishes
medium grit to smooth the work and fine grit
to finish off.
- The higher the grade number, the finer the
grit. For rough work, start with a low grade of
grit. (e.g.60grit) and change to a higher, finer
grade (e.g.120grit) for finishing.
B) Replacing the sand paper (See Fig. B)
Lift the Sand paper at the side and pull it off
the sanding plate. Clean the sanding plate, if
required. Press the new Sand paper against
the bottom of the sanding plate. To ensure
optimum dust extraction, the holes of the
Sand paper must match with those of the
sanding plate.
OPERATION
1. SWITCHING ON/OFF (See Fig. C)
Depress "Ⅰ" on the sliding on-off switch to
EN