Sanding Surfaces; Rough Sanding; Fine Sanding - Worx WX653 Manual Del Usuario

start the machine.
Depress "0" on the sliding on-off switch to
stop it.
2. VARIABLE SPEED CONTROL
(See Fig. D)
With the variable speed control dial (7), the
required speed can be selected (also while
running).
The required speed is dependent on the
material and is to be determined by a practical
trial.
After longer periods of working at low speed,
allow the machine to cool down by running it
for approx. 3 minutes at maximum speed with
no load.
Grain
Sanding
Coarse
work
sanding
Sanding
down 180
varnishes
Stripping
40
paint
Touching
up 120
paintwork
Sanding
60
wood
Machining
180
veneer
Sanding
80
aluminium
Derusting
40
metal
Sanding
metal and 120
steel
Sanding
180
plexiglass
3. DUST BOX (See Fig. E, F)
A) Attach the dust box (See Fig. E)
Your sander is equipped with a dust collection
box. To attach, slide the dust box onto the
outlet piece and take care that the dust box
Random orbital sander
Speed
Precision
setting(opm)
sanding
400 8700~11000
120 9800~11000
120 7600~10000
240 7600~11000
400 8700~11000
240 7600~11000
120 9800~11000
240 9800~11000
400 6500~8700
locks in the grooves of the outlet.
CAUTION: To prevent the possibility
of sanding dust or foreign body being
thrown into your face or eyes, never attempt
to use your sander without the dust box
properly installed.
B) Empty dust box (See Fig. F)
For more efficient operation, empty dust box
every 5-10mins. This will permit the air to flow
through the box better. To empty the dust box,
pull off the dust box out of the dust extraction
outlet directly and shake out dust.
4. USING THE DUST EXTRACTION
ADAPTER (See Fig. G)
Your sander is equipped with two dust
extraction adapters, which are designed for
connecting the hose of a vacuum cleaner.
If the vacuum hose is 35mm, Insert the 35mm
dust adapter (a) directly into the rear dust
outlet of sander. If the vacuum hose is 32 mm,
insert the 32 mm adapter (b) into the back of
35mm adapter (a).
NOTE: Please pull the dust adapter to make
sure tightened securely on the dust outlet.

5. SANDING SURFACES

Place the machine with the complete Sand
paper on the surface to be worked. Ensure
uniform sanding pressure. Less sanding
pressure increases the sanding capacity and
protects the machine and the sanding tool.
The removal capacity and the sanding pattern
are determined mainly by the selection of
the Sand paper (grain size), the speed of the
sanding plate and the application pressure.

ROUGH SANDING

Attach a Sand paper with coarse grain.
Apply only light sanding pressure to achieve
increased material removal.

FINE SANDING

Attach a Sand paper with fine grain. With
moderate pressure, move the machine in a
circular pattern or alternately in lengthwise
and crosswise directions over the work piece.
Do not tilt the machine to avoid sanding
through the work piece (e.g. when sanding
veneer). After finishing the work, switch off the
machine and lift it from the work piece.
9
EN