Replacing Carbon Brushes - Makita LS1013 Manual De Instrucciones

movable range of laser line is factory adjusted within 1
mm (0.04") from the side surface of blade.)
To shift the laser line movable range further away from
the side surface of blade, turn the two screws
counterclockwise after loosening the adjusting screw.
Turn these two screws clockwise to shift it closer to the
side surface of the blade after loosening the adjusting
screw.
Refer to the section titled "Laser line action" and adjust
the adjusting screw so that the cutting line on your
workpiece is aligned with the laser line.
NOTE:
Check the position of laser line regularly for
•
accuracy .
Have the tool repaired by Makita authorized
•
service center for any failure on the laser unit.
Cleaning of the lens for the laser light
For model LS1013L/LS1013FL only
006346
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no longer
easily visible, unplug the saw and remove and clean the
lens for the laser light carefully with a damp, soft cloth.
Do not use solvents or any petroleum-based cleaners on
the lens.
006347
To remove the lens for the laser light, remove the saw
blade before removing the lens according to the
instructions in the section titled "Installing or removing
saw blade".
Loosen but do not remove the screw which secures the
lens using a screwdriver.
Pull out the lens as shown in the figure.
1. Screwdriver
1
2. Screw (one
piece only)
3. Lens for the
2
laser light
3
1. Lens for the
laser light
1
NOTE:
If the lens does not come out, loosen the screw
•
further and pull out the lens again without removing
the screw.
Replacing fluorescent tube
For LS1013F/LS1013FL only
2
1
4
3
002028
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before replacing the fluorescent tube.
Do not apply force, impact or scratch to a
•
fluorescent tube, which can cause a glass of the
fluorescent tube to be broken resulting in a injury to
you or your bystanders.
Leave the florescent tube for a while immediately
•
after a use of it and then replace it. If not. You may
burn yourself.
Remove screws, which secure Lamp Box for the light.
Pull out the Lamp Box keeping pushing lightly the upper
position of it as illustrated on the left.
Pull out the fluorescent tube and then replace it with
Makita original new one.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
23
1. Pull out
2. Push
3. Lamp box
1
4. Screws
5. Fluorescent tube
5
1. Limit mark
1