Volvo Penta 3812500 Instrucciones De Montaje página 20

KIT (3812500) CONTENTS
Following is a list of parts contained in this kit. A description of the part and where it is used follows the part
number. Each part number is preceded by an image number; these numbers may be used to refer to the
illustrations following this table to easily identify parts. Note: Some of the hose clamps listed do not have
associated image numbers and are not shown in the illustrations.
Image # Part # Description
23514 3861544 Bracket
23516 3861919 Bracket
23519 3861475 Bracket
23515 3861849 Bracket Ay
23519 3861476 Bracket, Support
23515 1674083 Cap
N/A 3853794 Clamp, Band
N/A 3853794 Clamp, Band
23519 3863439 Clamp, Band
N/A 3863439 Clamp, Band
18
37. Using a 9/16 in. wrench, attach engine block
drain plugs A (PN 3850802) and tighten to
22 ft. lbs. (30 Nm).
23511
38. Attach a new double-hose tie strap B
(PN 3850115) on the raw water pump hoses
and tighten.
23512
Application
Stay, Raw Water Pump To Engine Block Front Starboard
Center Lift, Thermostat Housing Screw
Heat Exchanger To Engine Block Front Starboard
Expansion Tank To Fuel Cell Bracket
Heat Exchanger To Heat Exchanger Bracket Outer
Pressure, Expansion Tank
Hose - Fuel Cell To Heat Exchanger, Heat Exchanger End
Hose - Thermostat Housing To Expansion Tank Vent
Hose - Heat Exchanger To Expansion Tank Heat Exchanger End
Hose - Heat Exchanger To Starboard Manifold
Qty
1
1
1
1
1
1
1
2
1
2