Introduction; Important; Getting Started - Idexx SNAPshot DSR Reader Guia Del Usuario

Introduction

IDEXX's SNAPshot* DSR Reader provides an easy-to-use method of reading and
recording SNAP* test results. Using a touch-screen interface, the SNAPshot DSR
Reader offers easy data entry and navigation. Its leading-edge imaging technology
provides quick, accurate test results. Just insert the "snapped" device and read the
test results.
The SNAPshot DSR Reader offers two test modes:
Full Read—Lets you record the test lot ID, tech ID and sample ID. Provides
on-screen and printed test results. The Full Read mode is required for National
Conference on Interstate Milk Shipments (NCIMS) testing.
Quick Read—Provides on-screen and printed test results. In the United States,
the Quick Read mode does not meet NCIMS testing guidelines.
IMPORTANT: A printer is required for NCIMS testing. The SNAPshot DSR Reader
printer is available separately from IDEXX. Call 1-800-321-0207 for additional
information or technical services.

Getting Started

Your SNAPshot DSR Reader package contains the following components:
• SNAPshot DSR Reader and stylus
• Power pack and cord
• SNAPshot DSR Reader Operator's Guide
• SNAPshot DSR Reader performance check set
• Warranty card
• Certification of calibration
• Printer cable
Optional Equipment not supplied by IDEXX:
• PS/2 keyboard compatible with languages offered
Data Entry and Navigation
You select options, enter data and navigate through the screens of the SNAPshot DSR
Reader either by tapping the screen with your finger or with the stylus provided. A PS/2
keyboard can be connected to the SNAPshot DSR Reader via the PS/2 port labeled
and used to navigate through the screens. Tab and enter can be used for
navigation and alphanumeric keys will be functional to enter lot, sample and tech IDs.
IMPORTANT: Do not use any other implement (pen, scissors, etc.) to enter data or
select items on your reader's screen as doing so could cause permanent damage.
Initial Setup
Setting up your SNAPshot DSR Reader is easy and only takes a few minutes.
To set up the SNAPshot DSR Reader:
1. Position the reader on a flat surface in a well-ventilated area out of direct sunlight.
The SNAPshot DSR Reader should be used in a controlled environmental
temperature of 7°–30°C (45°–86°F). See the SNAP kit insert for specific assay
temperature requirements.
IDEXX SNAPshot* DSR Reader Operator's Guide 5