Caracterís Cas Técnicas; Instalación Y Pre-Operación; Posicionamiento - Skymsen PS-22 Manual De Instrucciones

PROBLEMS
-Lack of electrical energy;
-Worn or broken Gears;
-The unit will not turn on.
-Problem in the internal or
external electrical circuit of the
equipment.
-Problem in the internal or
-Burning odor and/or smoke. external electrical circuit of the
equipment.
-Worn or broken Gears;
-Alloy equipment but when
the product is placed on the
-Problems with the Electric
equipment, the same for or
Motor.
revolves low rota on.
-Transport of the product failure. Call authorized technical
-Electric Cable damaged.
-Strange noises. -Defec ve Bearings
-One of the components of the
mouth or incorrect moun ng of
-The processed product comes the same;
out crushed.
-Disks or Crosses blunt.
-Lack of electrical power on the
equipment;
-Problem in the internal or
-The nut screw to during
external electrical circuit of the
opera on
equipment;
-Worn or broken Gears.
- Sealing System of the damaged
* Oil leak in the gearbox.
equipment.
16
TABLE 02
CAUSES SOLUTIONS
-Check if there is Power;
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
Call authorized technical
assistance (ATA);
assistance (ATA);
Call authorized technical
assistance (ATA);
-Check the moun ng
sequence according to (fig.
03);
-See item 5.2.1 of this manual.
-Check that the plug is plugged
into the socket, and if there
is power to the electrical
network;
* Call authorized technical
assistance (ATA).
* Call authorized technical
assistance (ATA).
1.3 Caracterís cas Técnicas
CARACTERÍSITCAS UNIDAD
Producción Promedio kg/h
Tensión
Frecuencia
Potência
Altura
Ancho
Profundidad mm
Peso Neto
Peso Bruto
2. Instalación y Pre-Operación
2.1 Instalación

2.1.1 Posicionamiento

Su equipo debe ser colocado y nivelado en un lugar seco superficial y firme con preferencia
850 mm de alto.
TABLA 01
PS-22 PS-22
300 300
V 110 220
Hz 60 60
CV 2 2
mm 530 530
mm 325 325
720 720
kg 32 32
kg 40 40
FIGURA 02
850 mm
PS-22
300
220 or 230
50
2
530
325
720
32
40
25