Publicidad
Idiomas disponibles
Idiomas disponibles
Before installing, carefully read the safety
instructions at the beginning of this
manual, especially how to place the
MACHINE IN POWER ZERO CONDI-
TION - PRELIMINARY OPERATIONS.
1) After taking the machine out of the
packaging, proceed as indicated IN
"GENERAL NOTES ON DELIVERY".
2) Position on a flat surface
3) Caution - pollution hazard
DO NOT THROW P A C K A G I N G
AWAY INTO THE ENVIRONMENT
4) Open door (16)
5) Remove tank (15)
6) Especially the first time, wash the tank
with soap and water
7) Fill the tank with water
8) Make sure the outside of the tank is dry
9) Refit the tank (15) in its housing
10)Close the door (16)
11)Make sure the water collection tray
(14) is well fitted
12) The dispenser nozzle (12) can be po-
sitioned in two ways:
20
INSTALLATION
a) high cups
fig. A
b) normal cups
fig. B
13)Make sure the mains voltage corre-
sponds to that shown on the rear.
14)Fit the plug in the socket only if the
machine switch (1) is in "O" off position
and the mains voltage corresponds.
15)End of preliminary operations. T h e
machine is ready to be prepared for
operation.
HOW TO PREPARE OR SET UP THE
MACHINE
Note: in the event of the following sequen-
ce not occurring, refer to the "TROUBLE-
SHOOTING" chapter.
After terminating the preliminary opera-
tions:
1) Press the machine switch (1), the start-
up indicator light (2) will start flashing.
Basic version: heating begins straight
away.
Plus Version: the machine automati-
cally fills the boiler with water (initial
time about 40 seconds). When level
has been achieved, heating starts.
NOTE the machine features a
safety system which, after about 2
minutes of continuous pump ope-
ration, stops the machine (to pre-
vent the pump from overheating)
and notifies alarm condition by
means of flashing of indicator
lights (2) and (3).
In this case, turn off the machine
by means of master switch (1) and
then turn it back on again.
During heating, the start-up light (2)
flashes.
2) Wait for the heating indicator light (2)
to stay permanently on. This means
the water has reached the proper tem-
perature.
3) Note: if the water indicator light (3)
comes on, this means the water tank
(15) is empty or is about to empty.
In this case, proceed as follows: switch
off the machine by pressing switch (1);
fill the tank with water; press the swit-
ch (1) again to start up the machine.
4) Note: remember that to make a good
drink, it is best to use the cup heater
(18) to keep the cups hot.
5) The machine features 3 filters marked
1,2,3 respectively on the sides.
Thanks to these filters, the machine
can be adapted to different types of
c o ffee according to the following dia-
gram.
Filter No. 1: recommended for strong
espresso
Filter No. 2: recommended for normal
espresso
Filter No. 3: recommended for weak
espresso.
Publicidad
