Publicidad
Idiomas disponibles
Idiomas disponibles
Before each use check:
> The webbing is not damaged, cut or worn, and that the stitching is intact
> The buckles and attachment points are not defective or missing
> If the harness fails inspection, it must be taken out of service and replaced immediately
> A competent person must do a full inspection annually
Never:
I
> Attach more than one hook to an attachment point
> Modify the harness in any way
> Work without a fall arrest system if there is the risk of falling
This product must be:
> Personally issued to a wearer
> Stored away from any source of heat
> Used only by trained personnel
> Used with locked karabiners and hooks
> Destroyed after being used to arrest a fall
c.)
> Not be exposed to chemicals which may dam the webbing buckles (potassium, chlorine, acids, etc.)
> Protected from contact with sharp edges and abrasion
> Cleaned with the following: thinners acetone ether soap etc.
> Dried naturally away from direct heat or flames
> Used with an anchorage point preferably above the position of the wearer
Anchor points:
> Dorsal safety line anchor point with extension [NT02 NT03 NT04 NT05]
> Sternal safety line anchor point (advised escape point) [NT03 MT05]
Note: the sternal anchor point should always be used by joining together the two loops.
> Work positioning attachment points: lateral (side) [NT04 NT05]
Method of use:
1) Unfold the harness and place the straps so that they are not twisted.
2) Put the harness on like a jacket.
3) Do the harness up closing all the buckles from top to bottom.
4) Adjust the straps without making them so tight that they restrict the movement.
NT90007803 IND B.indd 3
GB
25.10.2011 6:50
Publicidad
