Operation And Maintenance; Technical Parameters - GRAPHITE 58G971 Manual De Instrucciones

Unplug the power cord from the mains socket before commencing any activities related to
installation, adjustment, repair or maintenance.
MAINTENANCE AND STORAGE
● Cleaning the device after each use is recommended.
● Do not use water or any other liquid for cleaning.
● Do not use any cleaning agents or solvents, they may damage plastic parts.
● Clean the tool with a dry cloth or blow with compressed air at low pressure.
● Clean ventilation holes in the motor casing regularly to prevent device overheating.
● In case of excessive commutator sparking, have the technical condition of carbon brushes of the motor
checked by a qualified person.
● Always store the tool in a dry place, beyond reach of children.
REPLACEMENT OF CARBON BRUSHES
Immediately replace worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both carbon brushes at a time.
● Move the main handle lock (8) back.
● Turn the main handle around long axis of the tool body to one of extreme positions (in relation to base
position), so the carbon brush can be accessed.
● Unscrew carbon brush cover (3) (fig. H).
● Remove worn out carbon brush.
● Remove any carbon dust with compressed air.
● Insert new carbon brush. Brush should easily move into brush holder (fig. I).
● Fix carbon brush cover (3).
● Move the main handle lock button (8) to the back again and rotate the main handle by 180° from its
position.
● Repeat the above procedure for the other carbon brush.
After the carbon brushes are replaced, start the saw with no load and wait 1–2 minutes until the
carbon brushes fit to the motor commutator. It is recommended to entrust replacement of carbon
brushes only to a qualified person. Only original parts should be used.
All defects should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Supply voltage
Power supply frequency
Rated power
Blade stroke cycles (without load)
Maximum thickness of cut material
Blade stroke length
Protection class
Weight
Year of production

OPERATION AND MAINTENANCE

TECHNICAL PARAMETERS

Reciprocating Saw
Parameter
Wood
Metal
16
Value
230 V AC
50 Hz
900 W
0-2600 min
-1
115 mm
8 mm
20 mm
II
2,74 kg
2016