Accuracy Check Of The Measuring Tool - CST/BERGER 58-iLMXL Manual De Instrucciones

Ocultar thumbs Ver también para 58-iLMXL:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
Operating Mode
– To switch off the measuring tool, press the operating mode button
2 until the tool switches off.

Accuracy Check of the Measuring Tool

Apart from exterior influences, device-specific influences (such as heavy
impact or falling down) can lead to deviations. Therefore, check the
accuracy of the measuring tool each time before starting your work.
Checking the Horizontal Line from Front to Rear (see Fig. C1)
– Choose two walls approx. 5 m apart.
– Set up the measuring tool approx. 30 cm from wall (W1), project the
laser cross onto wall (W1) and mark the point on the wall as "a1".
– Rotate the tool by 180°, project the laser cross onto the opposite
wall (W2) and mark the point where the laser cross hits the wall as
"b1".
– Now, set up the measuring tool approx. 30 cm from wall (W2),
project the laser cross onto wall (W2) and mark the point on the wall
as "b2".
– Rotate the tool by 180°, project the laser cross onto the opposite
wall (W1) and mark the point where the laser cross hits the wall as
"a2".
– Measure the distance between "a1" and "a2" and between "b1" and
"b2."
1 609 929 T56 • 24.2.09
Laser cross
Offset laser cross (manual
operation)
Applicational Example
English | 21

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido