Publicidad
INSP
ADJ
CONTROL SYSTEM
2. Adjust:
G
QSTS cable
Adjustment steps:
G
Set the control grip in the neutral posi-
tion.
G
Loosen the locknut 1.
Remove the nut 2 and pivot pin 3.
G
Position the jet throttle nozzle so that
G
a and b are equal in length.
Turn the cable joint 4 for adjusting.
G
Turn in
Turn out
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
G
Connect the cable joint 4 and pivot
pin 3 and tighten the nut 2.
Nut:
4 N • m (0.4 kgf • m, 2.9 ft • lb)
Tighten the locknut 1.
G
Locknut:
3 N • m (0.3 kgf • m, 2.2 ft • lb)
NOTE:
If the QSTS cable cannot be properly
adjusted by the cable joint at the QSTS con-
verter end, adjust the cable joint at the jet
pump end so that the same lengths are
obtained. Refer to "REMOTE CONTROL
CABLES AND SPEED SENSOR LEAD" in
Chapter 8.
3-5
Length b is increased.
Length a is increased.
E
Publicidad
Capítulos
