Preparation Before Installation; Installation Steps - Rampage Trail Ram Bumper Rear Instrucciones De Instalaión

Preparation Before Installation

• A test fit is recommended to ensure proper positioning and fit.
• Check fit parts before painting as we will not accept the return of modified or painted parts are not returnable.
• Remove contents from the box and check for missing pieces or damage. If parts are missing or damaged, please contact
original place where item(s) were purchased.

Installation Steps

Remove the 4 bolts from the bumper brackets on the
framerails (2 on each framerail). Save hardware for later use.
1
Remove the trailer wiring plug from the factory bumper and
remove the factory bumper.
Remove the rear tow hook from the frame.
3
Remove the 4 screws at the back of the rear inner fender
wells that go into the bumper. (2 in each fenderwell)
Remove the 2 bolts from the rear crossmember that secure
the factory rear bumper brackets, and loosen the 2 top bolts
and swing the brackets up above the rear crossmember.
2
Insert the new rear bumper mounting brackets into the
framerails and line up the welded nuts of the brackets with
the 2 oval holes on the outside of each framerail.
4
Page 2 of 4