Installation Steps - Rampage TrailView Tube Half Doors Instrucciones De Instalación

Installation Steps

Door Strap/Harness location
Unplug the wiring harness
connector under the instrument
panel by pressing the tab at the
top of the connector and pulling
to disconnect.
NOTE: If the red latch on the
connector is locked, pull the red
latch down. This will unlock the
connector tab, allowing the tab to
be pressed down and enabling
the harness to be disconnected.
1
Remove the trim access door from the bottom of the B-pillar. Unplug the wiring harness connector.
2
Install driver's side hinge pins. Attach the hinge pin with three 8M hex bolts. Use large flat washers on both sides of the door, then lock washer the nut. Face the
bolts in. Leave the bolts loose for now. *Note: upper hinge pin is different than the lower hinge pin.
3
4
NOTE: Actual application may vary slightly from illustrations.
Page 2 of 4
Remove the hinge pin screws from the upper
and lower outside hinges (using a #T50
Torx® head driver).
4 Door Rear Door Removal ONLY