Setup; Safety Information; Assembling The Shower And Toilet Commode - Invacare Aquatec Ocean Manual Del Usuario

Aquatec® Ocean / Ocean XL

4 Setup

4.1 Safety information

WARNING!
– Check the parts for transport damage before
commissioning and contact your dealer if
required.
– Ensure during assembly that the parts are
positioned correctly with respect to one
another.
– Self locking screws, nuts or thread locking
adhesive are used for several connections. If
these are loosened, they must be replaced by
new self locking screws, nuts or they must be
secured using new thread locking adhesive.

4.2 Assembling the shower and toilet commode

This section describes the assembly. Disassembly takes place
in the reverse order.
Fitting the seat frame tube for height adjustment
10
1. Remove the enclosed clips F from the bag.
2. Place the seat frame on its side.
IMPORTANT
– Push the side part evenly onto the frame and
do not twist.
– Secure the side part at the same height, front
and rear.
3. Push the side part A with the guides for the footrests
D forwards on the seat frame B.
4. Bring the clip mounts E on the front and back of the
side part in line with a hole in the seat frame C.
5. Insert the clips F from the outside into the side part,
until both ends G enclose the seat frame tube B.
IMPORTANT
– Ensure that the left and the right side parts are
set to the same height.
1552757-G