Cleaning Instructions; Maintenance Instructions - Bauerfeind CaligaLoc Guia De Inicio Rapido

Cleaning instructions

Note: Never expose the CaligaLoc® to direct heat (e.g. heater, sunlight, in
your car, etc.)! This could damage the material. This can impair the
effectiveness of the CaligaLoc®.
First undo all of the Velcro fastenings. Then pull each strap out of its loop
completely. Fasten the ends back onto the straps to avoid any damage. Use a
damp cloth to wipe the shell and cushion. Use a mild cleanser.
Hand wash Do not bleach

Maintenance instructions

With correct handling and care, the product is practically maintenance-free.
Assembly instructions
The CaligaLoc® is supplied ready for use.
Technical data/parameters, accessories
The CaligaLoc® is an ankle orthosis with three attached straps. The straps
are not removable.
Notes on reuse
The CaligaLoc® is intended for your sole use and has been individually
adapted for you. For this reason, do not pass the CaligaLoc® on to other
people.
Warranty
Warranty is provided in accordance with the statutory provisions as well as
the terms of supply and contractual terms of Bauerfeind AG (general terms
and conditions), as long as all the points mentioned above are observed.
If you have any complaints, please contact your medical retailer only. Please
note that only clean goods can be dealt with.
Disposal
You can dispose of the CaligaLoc® in accordance with national legal
requirements.
Version: November 2011
10
Do not tumble-dry Do not iron Do not dry-clean
Specialists
General notes
• Check the optimal and individual fit of the CaligaLoc® at the first fitting.
Make any corrections if necessary.
• Practice the correct procedure for putting on the orthosis with the
patient.
• The product must not be changed in any improper way. Failure to comply
with this requirement may adversely affect the medical and therapeutic
effectiveness of the product, thereby voiding any product liability.
• The CaligaLoc® is intended for the treatment of one patient only.
Adapting the CaligaLoc®
Adjusting the plastic shell
Check the fit of the CaligaLoc® on the patient. Pay careful attention to
I
the patient's individual anatomy (e. g. the lateral malleolus).
remove the cushion from the plastic
CaligaLoc® using a hot-air gun at 120-140 °C.
when you are doing this. Glue the inner cushion back into the plastic
IV
shell.
Adjusting the cushion
If the ankle is badly swollen and the cushion is therefore pressing against
V
the lateral malleolus, we recommend making a cutout in this part of the
cushion. Use sharp scissors or a cutter knife und cut along the embossing.
II Carefully
shell. If necessary, adapt the
III
Wear protective gloves
11