Canifugue Pro Receiver Collar - Num'axes CANIFUGUE Pro Manual De Instrucciones

Ocultar thumbs Ver también para CANIFUGUE Pro:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Warning area indicator
Stimulation area
indicator
connect the transmitter to the power supply by plugging the AC adapter into the power jack on the transmitter and into a wall outlet.
Indications appear on the LCD screen, the transmitter is On.
disconnect the AC adapter from the wall outlet.
The LCD screen goes out, the transmitter is Off.
NOTE: do not connect the transmitter to the power supply before connecting the antenna wire to the antenna socket. The wire break alarm would alert
you to a connexion default (ref. § Safety features).
When you disconnect the transmitter, the boundary settings are memorized. Next time you will activate the transmitter, the settings will be the last
selected.

CANIFUGUE PRO receiver collar

Contact points
(short or long)
Area where the magnetic switch is located
This magnetic switch allows you to turn On/Off the
collar and to select the stimulation level (modes)
To charge your collar, proceed in the following way:
− connect the charger to a wall outlet
− connect the power cord to the collar (after a few seconds, the green indicator light starts blinking every 5 seconds)
− when the battery is fully charged, the green indicator light goes out
− disconnect the charger from the collar and put the protection tab back in place
− disconnect the charger from the wall outlet
We advise you to fully charge the battery before the 1st use.
A full charge takes approximately 3 hours.
You can purchase a car charger from your supplier at any time.
The supplied magnetic key allows you to activate/deactivate the collar.
move the magnetic key towards the collar so that it comes into contact with the area
where the magnetic switch is located (ref. Diagram 5). Keep them both in contact a few seconds.
The collar will emit 2 beep sounds and the green indicator light will flash every 5 seconds indicating
that the collar is On.
Diagram 3 LCD screen
Diagram 4 CANIFUGUE PRO collar
Area where the green
indicator light is located:
On/Off indicator
+
Battery charge level
indicator
Magnetic key
(magnet)
r
Gb - 18
Small / large ground
indicator
Broken antenna wire
or connection default
indicator
Charging jack
protection tab
Diagram 5
Activate/deactivate
the CANIFUGUE PRO collar
with the magnetic key

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Canifugue mix

Tabla de contenido