Testing The Pet Fencing System (Boundary Range); Adjusting The Stimulation Level - Num'axes CANIFUGUE Pro Manual De Instrucciones

LCD screen
IMPORTANT: the widths indicated are approximate and vary depending on the configuration of each installation.

Testing the pet fencing system (boundary range)

Before releasing your dog into his play area, you need to physically evaluate the extent of the authorized zone. Make sure your dog has enough space
to move freely within the defined limits.
The wider the zones, the lower the escape risks. Therefore, you have to find a good compromise between zone width and freedom space.
In order to test the installation, proceed as follows:
− Before doing so, make sure the receiver collar is turned Off (CANIFUGUE PRO: green indicator light Off – CANIFUGUE MIX: battery removed from its
housing).
− Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and retightening them so as to pinch the test lamp wires).
− Turn On the transmitter and the receiver collar.
− Put the selector in position "small or large ground" according to your installation.
− Set the warning and stimulation zones on the levels that seem appropriate.
− Stand at the centre of the authorized area holding the collar by the strap at the same height and orientation as if on your dog's neck. Then walk
towards the edge of your property where the antenna wire is laid. At a certain distance from the wire, the collar should emit beep sounds. Then, when
you carry on, the neon test lamp should light indicating stimulations are emitted. If you think the zones are insufficient or too important, go back to
the transmitter to modify the settings. Use the
of the stimulation zone. Change the selector position. Check the new settings on your property. Test the settings in a number of different areas of the
installation to ensure that the functioning is constant.
− When the zone setting is complete, walk all around the authorized area holding the collar by the strap at the same height and orientation as if on your
dog's neck in order to check that there is no loss of signal.
− Before disconnecting the neon test lamp, make sure the receiver collar is turned Off (CANIFUGUE PRO: green indicator light Off – CANIFUGUE MIX:
battery removed from its housing).
WARNING: Do not test or adjust the system while the collar is on your dog.

Adjusting the stimulation level

8 stimulation levels (modes) are available on each CANIFUGUE PRO/CANIFUGUE MIX collar so you can adjust the product to your dog (size, sensitivity,
temperament).
In the factory, the collar is set on mode 4.
Always start with a low level of stimulation and define the level from which your dog reacts by increasing gradually.
100 m installation, selector position « small ground »
Zones setting
(levels)
MINIMUM warning = 1
MAXIMUM warning = 40
MINIMUM stimulation = 0
MINIMUM warning = 21
MAXIMUM warning = 40
MAXIMUM stimulation = 8
and buttons to modify the width of the warning zone. Use the
Gb - 21
Approximate width of the zones
on each side of the wire
MINIMUM warning ~ 0.5 m
MAXIMUM warning ~ 5.5 m
No stimulation area.
Only beep sounds are emitted.
MINIMUM warning ~ 2 m
MAXIMUM warning ~ 5.5 m
MAXIMUM stimulation ~ 2 m
button to modify the width