Siefken SDS8 Instrucciones De Uso página 18

3 YEARS
L I M I T E D WA R R A N T Y
Additional Safety Instructions for Demolition Hammer
1. Wear ear protectors. Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool. Loss of control can cause personal injury.
3. Hold power tools by insulated gripping surfaces, when performing an operation where the
cutting tool may contact hidden wiring or its own cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of the power tool "live" and could give the operator an
electric shock.
4. Wear a dust mask.
5. Be sure the bit is secured in place before operation.
6. Under normal operation, the machine is designed to produce vibration, the screws and bolts
can come loose, causing a breakdown and accidents. Check tightness of them carefully before
running.
7. In cold weather or a long time tool not be used, please keep the tool running without load a
few minutes to warm up the grease inside, otherwise hammering function is di cult to get.
8. Be sure you stand stably and no one is below when you using tool is in high location.
9. Hold the tool rmly with two hands.
10. Don't touch any moving parts.
11. Don't leave the tool running itself, operate tool only when hand-held.
12. Don't point the tool to anybody for the bit could y out in case.
13. Don't touch the BIT OR PARTS CLOSE TO THE BIT immediately after operation, they may
extremely hot and could burn your skin.
14. Any damage and abnormal happen, please stop to use immediately and disconnect it, ask
authorized serve center to check and repair.
15. Parts replace: Only original Siefken's parts can be used to replace by authorized service
center.
16. Right use accessories and parts: Don't use other parts and accessories which not mentio-
ned in the manual otherwise may cause injuries!
17. Special attention to voltage: Before connect the power tool, please make sure the rated
voltage on the tool can match the power supply, otherwise the power tool may be damaged
and cause injuries.
18. Don't wipe plastic part with solvent: Solvent such as gasoline, thinner, alcohol etc. these
kind of chemical material, are not allowed to use, water or soap are recommended!
19. In case of damages the replacement of the plug or the supply cord shall always be carried
out by the manufacturer of the tool or his service organization.
4