Operation - Siefken SDS8 Instrucciones De Uso

3 YEARS
L I M I T E D WA R R A N T Y
5. Operation instructions
Prior to operation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up use of this products.
1. Power source
Ensure that the power source to be utilized conforms to the power requirements which speci-
ed on the name plate of the hammer.
2. Power switch
Ensure that the power switch is in the position of OFF. If the plug is connected to power recep-
tacle while the power switch is in ON position, the demolition hammer will start operation
immediately, which can cause serious accident!
3. Extension cord
When the work area is removed from the power source, use an extension cord of su cient thic-
kness and rated capacity. The extension cord should be kept as short as practicable.
Switch operating
Observe correct mains voltage! The voltage of the power source must agree with the voltage
speci ed on the type plate of the power tool.
For low temperatures, the power tool reaches the full impact rate only after a certain time.
Shock absorption Equipment
The is equipped with an active vibration reduction system, which cuts vibration of that of the
without Active Vibration Reduction. This may signi cantly reduce the exposure level over the
total working period. protect the operator form the e ects of vibration.
6