LIMIT 5600 Manual Del Usuario página 4

3. Drop a little oil, grease or similar on the material to be
measured.
4.Press the probe on the material. ((●)) symbol shows
on the display and confirm contact between probe and
material.
5. Read the value. The display hold last value till next
measurement or power off.
Select material code
1. Push the SELECT-button.
2. Select with ▲▼-buttons correct material code.
3. Push the SELECT-button again to confirm.
Last selected code are stored for next operation.
Select velocity speed
1. Push the VEL-button.
2. Select with ▲▼-buttons correct velocity speed.
3. Push the VEL-button again to confirm.
Last selected velocity speed are stored for next
operation.
When velocity speed is unknown the velocity speed
can be set by testsample with known thickness
1. Make a first measurement on the testsample.
2. Increase or decrease velocity speed as above.
3. Make a new measurement. Increase or decrease
velocity speed till the value on the display is same as
testsamples real thickness.
Calibration
1. Push the CAL-button.
2. Drop a little oil, grease or similar on the test block,
placed on instrument right side.
3
English