Recalling A Plu From The M-Key; Fractional Pricing ( Only For Version B ) - OHAUS Aviator 3000 Serie Manual De Instrucciones

Aviator 3000 Series
3.

4.8.2.2 Recalling a PLU from the M-Key

1.
2.
Note: If pressing an M-key with no stored data, "noPLu " will show
momentarily in the Weight display.
4.9 By-Count Function (Version B)
The By-Count function is used as reference to calculate the price of non-
weighing items, e.g., the price for 36 pieces when 3 pieces cost a total of
$1.50.
1. Enter the deal quantity (1-99), e.g., "3 ", then press [X]. The X
annunciator will turn on to indicate the scale is in the By-Count mode.
2. Enter the deal price, e.g., "1.50 ", then press [FIX]. The Unit Price
display will show "1.50".
3. Enter the quantity to be sold, e.g., "36 ". The resulting total price of
"18.00 " is shown in the Total Price display. Keep entering another
quantity as needed.
4. To end the By-Count function and return to normal weighing mode,
press [C].
4.10 Fractional Pricing (Version B)
If permitted by state law, and with Fractional Pricing enabled in the Service
Setup mode accordingly, press 100 g successively to price in € per 100 g,
return to normal Unit Price mode.
To enable Fractional Pricing in the Service Setup mode:
1. Perform Step 1 in Section 6.1.
"S1 oFF " is displayed momentarily. Press [PLU] [5] [5] [5] [5] [5].
2.
"SCL" is displayed. Press [FIX].
3.
4.
"Step 1 " is displayed. Press [FIX] successively to move through
parameters Step 1 to 19*.
When "Step 19 oFF " is displayed (this parameter enables 100g
5.
pricing), press [>T<] to change the setting to "on ", then press [PLU] to
proceed to "SAVE ".
If set to store two PLU's per M-key, press and hold the desired
M-key until the long beep, then quickly press the M-key again
within 1 second. "L2 " appears momentarily to indicate the data
is stored in the second memory location of that M-key
Press the M-key with the pre-stored data. The corresponding
Unit Price/Tare value will be displayed.
If set to store two PLU's per M-key, quick press the M-key twice
within 1 second. "L2 " appears momentarily, then the
corresponding Unit Price/Tare value.
EN-13
.