ESD GROUNDING PRECAUTIONS SHOULD BE
OBSERVED. FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY RESULT IN DAMAGE TO THE SYSTEM AND/OR
SAFETY HAZARDS.
The following procedure is provided in the unlikely event
that the system fiber optic handpiece needs to be replaced.
1) Completely unwrap the fiber from the fiber wrap and
carefully store on a counter top. Remove the outer cover
of the fiber wrap, using the fiber replacement tool, by
depressing two locking/release tabs located inside the
wind wheel at the 10:00 o'clock and 2:00 o'clock positions
while simultaneously pulling the wind cover outward from
the top. Once the wind cover is loosened continue to pull
outward and down until it is removed.
2) With the cover of the fiber wrap removed the optical
fiber with hex nut that attaches to the diode laser assembly
is exposed. Rotate the hex nut, by hand, counterclockwise
to remove the fiber from the diode laser. When loose,
remove the fiber from the system via the opening in the
fiber wrap.
3) Install the replacement fiber in reverse order as
described above. Attach fiber wrap cover by inserting
bottom mounting tabs and pushing inward from the top
until it snaps and locks into place. Wrap the optical fiber
loosely around the fiber wrap and install handpiece into
magnetic mount on the system front panel.
all oTHer CondITIons
In the event that the SOL fails to operate correctly, and
your DenMat Representative is unable to help, the unit
will need to be returned to DenMat for repair. There are
no user-repairable parts found with the device. It
is recommended that the SOL is returned in its original
shipping box. If not available, one can be requested
at the time you discuss your return with your DenMat
Representative.
send reTurns To
Repairs
DenMat Holdings, LLC
1017 W. Central Ave.
Lompoc, CA 93436 USA
Tel.: 805-347-7990
12
12
m sysTEm WARRAnTy
When used under normal operating conditions as described
in this Manual, the SOL Laser system is warranted to be
free of defects in materials and workmanship for two (2)
years from the date of original shipment.
Within the warranty period, all parts and service charges for
repairs to the SOL Laser system are covered by DenMat.
If service is required, the system must be returned to DenMat
for diagnosis and repair. Contact your Customer Service
Representative for Return Authorization prior to shipping
the System to DenMat. The Return Authorization will include
a pick-up notice (Call Tag) for a common carrier to return
the unit to DenMat. Freight charges for returns within the
warranty period will be paid by DenMat. Freight charges
for returns outside of the warranty period will be paid by
the customer. The outside shipping container and any
accompanying documents must be clearly marked "Repair
Return. " Use only the original shipping container or other
adequate shipping materials to protect the system in transit.
Repairs may be made with new or refurbished parts, at the
manufacturer's discretion.
Returned units that are outside the warranty period will be
evaluated for the cause and extent of failure or damage
by DenMat Service Representatives. Subject to the results
of this evaluation, DenMat will contact the customer with a
price quotation for the cost of repairs.
This is a limited warranty and the liability of DenMat is to
repair or replace the system with new or refurbished parts.
DenMat has no liability to refund any part of the purchase
price and no liability for consequential damages, loss of
profits, and damages to person or injury by reasons of any
defects in said system from any cause whatsoever. Any
buyer who purchases said system acknowledges their
familiarity with the terms, conditions, and provisions of this
limited warranty and purchases said system agreeing to
such terms, conditions and provisions.
Buyer purchases the SOL Laser system from DenMat on
the terms, conditions, and provisions of this limited warranty
and waives all other rights and claims against DenMat for
any damages or remedies exceeding said limited warranty.