General Safety; General Safety Considerations; Eye And Skin Protection; Emergency Shutdown Options - DenMat SOL Instrucciones De Uso

DANGER
Wavelength: 808nm
Max Output Power: 3W CW, 5W Pulse
Pulse Duration: 0.05 seconds
e gEnERAl sAFETy WiTh ThE
sOl lAsER

general safeTy ConsIderaTIons

Safe use of the SOL Laser is the responsibility of the entire
dental team including the doctor, any system operators and
the dental office safety officer.
Electromagnetic Environment Guidance
(Class B (CISPR 11:2009), Group 1 per
IEC 60601-1-2, sub-clause 6.8.3.201)
The SOL Laser uses RF Energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby electric
equipment.
Floors should be wood, concrete, or ceramic tile. If floors
are covered in synthetic material, the relative humidity
should be at least 30%
Mains power quality should be that of a typical
commercial or hospital environment. The SOL Laser
does not require continued operation during power mains
interruptions, merely it is recommended that the SOL
Laser should be powered from an uninterruptible power
supply (UPS) or its battery.
Power Frequency Magnetic Fields should be at levels
characteristic of a typical location in a typical commercial
or hospital environment.
4 4
LASER RADIATION. AVOID EYE OR SKIN
EXPOSURE TO DIRECT OR SCATTERED
RADIATION.
LASER PROTECTIVE EYEWEAR REQUIRED
CLASS IV LASER PRODUCT

eye and skIn ProTeCTIon

While the SOL Laser is in use, doctors, system operators,
auxiliary staff, patients, and anyone in the operatory must wear
the appropriate safety eyewear that has been designed for
use with the 800-plus nm wavelengths associated with lasers.
Eye protection must conform to Specification DIN EN207
Annex II of the Directive 89/686/EEC with optical density of
OD+4 for the wavelength range of 800nm-818nm such as
NoIR Laser Company filter model DI1.
Nominal Ocular Hazard Distance (NOHD) is the distance
from the source of laser emission to the point where it no
longer exceeds its Maximum Permissible Exposure (MPE
– highest level of laser radiation to which a person may be
exposed without hazardous effects or adverse biological
changes in the eyes or skin). The Nominal Hazard Zone
(NHZ) is the space within which the level of direct, reflected,
or scattered radiation during normal operation exceeds the
appropriate MPEs. The outer limit of the NHZ is equal to
the NOHD. The NOHD for persons wearing recommended
safety glasses is shown in Table 1 below.
Table 1: noHd (InCHes/Cm)
Radiation MPE mW/ Divergence
Source cm 2 Angle
Fiber 1.66 9° (+/- 1°)
Optic Tip
(direct)
Reflected 1.66 n/a
from
Tissue
Never point the SOL Laser tip directly at the face, eyes or
skin of anyone while emitting energy.

emergenCy sHuTdoWn oPTIons:

Perform any of these actions to terminate laser
emissions in the event of a real or perceived
emergency:
•
Depress the emergency "STOP" button (Fig. 1.5)
•
Remove your foot from the foot switch
•
Press the "Ready" button (Fig. 1.10)
•
Turn the key counterclockwise to the "OFF" position
•
Switch the power switch to the "OFF" position
•
Remote interlock open circuit deactivates laser
Without With
Eye Recommended
Protection Eye Protection
155/393.7 1.55/3.94
0.25/0.63 0.0025/0.0063