Dash Disassembly - Metra 99-9606 Instrucciones De Instalación

1. Remove the (1) T-30 Torx screw
from each of the small carpeted
panels under the dash, at the front
of the center console on each side.
(Figure A)
2. Remove the (2) T-15 Torx screws
from the left and right dash side
trim panels, then unsnap and
remove the panels. (Figure B)
3. Open the gloveblox and unscrew
the (1) 7mm set screw from the
passenger side of the radio (about
the center of the radio). (Figure C)
4. Using a 5mm Allen wrench, unlock
(2) latches from each side of the
radio with a half turn of the wrench.
(Figure D)
5. Unsnap and remove the factory radio.
Continue to kit assembly

Dash Disassembly

(Figure A)
(Figure B)
99-9606
(Figure C)
(Figure D)
2