Kit Assembly - Metra 99-9606 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Attach the pocket to the radio brackets
using the (4) #8 x 3/8" Phillips pan-
head screws provided. (Figure A)
3. Slide the radio into the bracket/
pocket assembly and then secure
it using the screws supplied with
the radio. (Figure A)
Note: The screws must be flush
in the radio brackets in order to
properly slide into the factory
sub-dash. (4) 5mm x 12mm
Phillips flat-head screws have
been supplied if the radio does not
supply these type of screws.
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or AXXESS. Test the radio
for proper operation .

Kit Assembly

5. Snap the radio into the dash, then
snap the radio trim panel over
the radio, and then reassemble
the dash in the reverse order of
disassembly.
Note: Once the radio is snapped
in it will not release unless the
entire radio sub-dash assembly is
removed.
(Figure A)
99-9606
ISO DDIN radio provision
1. Attach the radio brackets to the
radio using the screws supplied
with the radio. (Figure A)
Note: The screws must be flush
in the radio brackets in order to
properly slide into the factory
sub-dash. (4) 5mm x 12mm
Phillips flat-head screws have
been supplied if the radio does not
supply these type of screws.
2. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or AXXESS. Test the radio
for proper operation .
3. Snap the radio into the dash, then
snap the radio trim panel over the
radio, and then reassemble the dash
in the reverse order of disassembly .
Note: O nce the radio is snapped in
it will not release unless the entire
radio sub-dash assembly is removed.
3
(Figure A)