Stalgast 9725000 Instrucciones De Uso página 20

• During operation, the unit heats up. It is important to be aware of the possibility of burns on contact
with its surface and with oil in the compartment. When the device is turned off, its temperature drops
slowly. Make sure that the bowl is empty and the temperature of the appliance has dropped to a safe
level before transport or any maintenance work.
• Before draining oil from the compartment, make sure that the elbow is screwed into the tap (Fig. 12 Pos.
2 and Pos. 4) as instructed, and the oil temperature has dropped to a safe level.
• Do not wash the appliance under running water.
• Any repairs may only be performed by qualified technical personnel (technical service).
• The device 9725500 is equipped with an overflow drain preventing the oil from leaking out of the device
• Fire hazard - Lowering the oil level below the minimum liquid level indication may lead to the oil
igniting.
3. SPECIFICATION OF THE DEVICE
3.1. Unit's front equipment 9725000, 9726000, 979250 (page 2 Fig. 1a,b):
1 - Control panel, 2 - Safety button (device reset), 3 - Drain valve lever, 4 - Drain pipe 5 - Control knob,
6 - Green light (signals power supply), 7 - Orange light (signals active heating)
3.2. Unit's front equipment 9725500 (page 2 Fig. 1)
1 - Orange light (signals active heating), 2 - Green light (signals power supply), 3 - Safety button (device
reset), 4 - Drain valve lever 5 - Overflow pipe, 6 - Waste oil container, 7 - Waste oil container
Model
External dimensions (mm)
Power (W)
Number of compartments
Maximum oil level (l)
Maximum disposable input (kg)
CWarm-up time to operating tempe-
rature (min.)
Performance (kg/h)
Dimensions of a single basket (mm)
Power supply
2
Power cord (mm )
4. INSTALLATION
• After unpacking, check whether the unit has any visible damage. If the unit was damaged during
transport it should not be connected!
• Before first use, please remove the protective film from the device. Wash the external surfaces with
a cloth soaked in warm water and a degreasing agent, and then dry. Do not use agents which could
scratch the surface
• Place the fryer 9725500, 979250 on a flat, stable surface and then level it with adjustable feet (Fig. 3).
• The appliance should be set on a worktop or a stable, leveled base (it is recommended to use the bases
manufactured in Stalgast Radom Sp. z o.o.). If necessary, the stove can be further leveled with adjustable
feet underneath the cabinet (Fig. 3)
Conditions for connection to mains:
• Make sure that the voltage in the mains corresponds to the voltage indicated on the rating plate of the
appliance
• To connect the appliance to the mains, connect the power cord to the terminal box on the back of the
Technical parameters of the device
9725000
400x700x250
9000
1
10
2
~26
210x350x110
5 x 2.5
Figure 3. Leveling the device
- 20 -
9726000 9725500
800x700x250 400x700x850
2x9000 1500
2 1
2x10 15
2 3
6
~52 ~45
310x340x150
400V, 50Hz
5 x 4 5 x 2.5
979250
400x700x850
9000
1
9
2
~26
210x315x110
5 x 2.5