Step 3: Drain Clamp Installation - brondell Capella Manual Del Proprietário

PRODUCT INSTALLATION

Step 3: Drain Clamp Installation

Before Installation
You will need to have these tools (not included) for the following installation: 1) drill, 2) 1/4-inch
drill bit, and 3) 3/8-inch drill bit
WARNING: This step may require drilling into the existing drain pipe. Please seek
professional help when completing this step, and always wear safety protection
including safety goggles!
1. Locate a suitable area on the sink drain pipe
to install the provided drain clamp.
NOTE: Select a location for the drain hole based
on the design of the plumbing. It should be installed
above the trap and on the vertical or horizontal
tail piece. Locate the drain connection away from
the garbage disposal. See example to the right.
2. You will need to drill a 3/8-inch hole in the drain pipe to install
the drain clamp. Use a 1/4-inch drill bit, and carefully drill a pilot
hole in the drain pipe. Use a 3/8-inch drill bit to enlarge the hole.
Clean the debris from the pipe and the hole before continuing.
DO NOT drill all the way through the pipe.
3. Find the half of the drain clamp with the hole in its center. Take
the foam gasket piece included with the hardware pack and
remove the adhesive backing. Align the foam gasket hole to the
hole on the drain clamp, and stick the adhesive to the inner wall
of the drain clamp half.
a. Insert a screwdriver, straw, or pencil through the hole on the
drain saddle to use as a guide.
Garbage
Disposal
Mount Drain
MOUNT
Clamp Here
DRAIN VALVE
HERE
Step 1
Step 2
Step 3a
11