Filter Replacement - brondell Capella Manual Del Proprietário

MAINTENANCE

Filter Replacement

After replacing the filters,
write down the date and
filters changed on this
Filter Change Chart
(a separate sticker is also
provided). It's important
to track each filter change
as the Activated Carbon
Plus and Carbon Block
Filters are on a more
frequent cycle than the
E2RO Membrane Filter.
A replacement faucet
battery is also included
with the RF-30 filters.
1. Close the T-valve under the sink to shut off the flow of water to
the Capella.
2. Once the T-valve is shut off, turn the Indicator Faucet on all
the way and keep it on until the water tank is emptied and the
pressure is released in the system. This should take about ten
minutes, and the stream of water will slow to a stop when the
tank has emptied. Turn the faucet off.
3. Remove each filter by turning to the left until the filter comes out
of the Filter Head Connection Assembly.
4. Install the new filters by following the procedure below.
NOTE: It is very important to install the filters in the correct order.
Match the same label colors to the filter head labels, from
left to right:
1) Activated Carbon Plus Filter
2) E2RO Membrane Filter
3) Carbon Block Filter
a. To insert the filters, first lineup the
arrow on the filter heads with the arrow on the filters.
Filters to Change
Activated Carbon Plus
Change 1
6 Months Carbon Block
Activated Carbon Plus
Change 2
6 Months
Carbon Block
Change 3 Activated Carbon Plus
6 Months
Carbon Block
Activated Carbon Plus
Change 4
Carbon Block
6 Months
E2RO Membrane
Total Time Date Changed
6 Months
/ /
12 Months / /
18 Months / /
24 Months / /
Filter
Head
Filter
Step 4a
Step 1
Step 2
21