11.2 Control and display elements
1
5
6
®
Fig. 14
Conex
DIA-G control panel
Pos. Description
Display elements
Red alarm LED
1
•
Flashes in case of faults or incorrect
entries.
Red sensor 1 LED
2
•
Flashes or lights up when a limit value is
exceeded for sensor 1.
Red sensor 2 LED
3
•
Flashes or lights up when a limit value is
exceeded for sensor 2.
4
Display
Operating button
[Esc] button
•
Returns to the previous menu.
5
•
The data which were entered last are not
changed.
[Up] button
•
Moves one line upward (the selected line
6
is displayed inversely).
•
Increases values.
[Down] button
•
Moves one line downward (the selected
7
line is displayed inversely).
• Decreases values.
[OK] button
•
Enters the selected menu.
8
•
Confirms the selected line or value.
28
2
3
4
7
8
11.3 Operating modes
•
Display mode: This is the standard operating
mode. The device automatically starts up in this
operating mode. In this operating mode it is
possible to:
– read current measured values
– read error messages
– acknowledge messages.
•
Menu mode: You can change to this mode by
pressing [OK]. In this operating mode you can
access various submenus in order to make
device settings, carry out tests, display data, etc.
You can return to the display mode from any
menu by pressing [Esc].
11.4 Display elements during initial
commissioning
On initial start-up, the "Language" selection menu
appears once the power supply has been switched
on, directly after the initial display.
Sprache..Language..
Deutsch
English
Español
Français
•
The word "Language" appears in the header in
each of the available languages, changing about
once every second.
Start the device by selecting the relevant operating
language:
1. Press the [Up] or [Down] button to select the
desired language.
– The selected language is displayed in inverted
format (white on black).
2. Confirm using [OK].
The selected language remains set for any
subsequent device start-up and can be
changed again, if necessary, via the
"Setup" and "Language" selection menus
Note
(these menus will be shown in the
previously selected language). See
section
11.8.1 Selecting the operating
language.