Operating Instructions - Grundfos Conex DIA-G Instrucciones De Instalación Y Funcionamiento

Once the language selection has been confirmed
using [OK], the measured value for the measured
variable "Chlorine" appears on initial start-up.
On subsequent start-ups, the last selected measured
variable appears in the display.
Cl
2
0.30 ppm

11.5 Operating instructions

11.5.1 Navigation in the menus
The operating keys are used for navigation in the
menus.
Press [OK] to access the main menu from the display
menu or to select the highlighted submenu from
other menus (row is in inverted format).
Within selection lists (submenus or settings), press
the [Up] and [Down] buttons for navigation.
Press [Esc] to exit the current menu and move to the
previous menu.
When scrolling (using the [Up] or [Down]
Note
button), the submenus above/below are
displayed.
11.5.2 Selecting and confirming settings
Numerical values such as limit values can be
increased and decreased using the [Up] and [Down]
buttons.
[OK] confirms the set value or the selection.
[Esc] exits the menu, and unconfirmed values are
not saved.
11.5.3 Display
Apart from in the display level, the display
Note
is generally in 5-line format.
Menu selection "Sensor 1" or "Sensor 2"
for parameterisation is displayed
Note
depending on the preselection in the
"Setup" menu.
Memory display on changes
If settings are changed in the submenus, this is
displayed within the relevant submenu on closing or
exiting this submenu.
This message is only displayed if changes are
implemented. It does not apply to the repeated
display of settings that have already been made and
are not changed.
Settings
saved
Measuring range exceeded
When a value exceeds the selected measuring
range, the display of the measured value remains at
the upper or lower measured value limit, and the
measured value flashes on the display.
See section 8.4 Measuring and setting
Cl
2
5.00
ppm
ranges.
29