Setting Up The Environment; Setup Mcu Board; Powering On Mcu Board - XYZ Robot A1-16 Manual Del Usuario

Setting Up the Environment

New servos must have an ID assigned to them before being included in an assembly.
NOTE: The Bolide Y-01 model was used for the following procedure. The illustrations may differ from
the model you purchased.

Setup MCU Board

1.
Connect the MCU board to your computer. Connect one end of a USB cable to the computer
(USB Type A) and the other end to the MCU board (USB Type Mini-B).

Powering on MCU Board

1. Plug the charger cable to the power socket on the MCU board.
2. Press the power switch to turn on the Bolide Y-01.
01