Setting Up The Servo Tool; Installing Servo Tool; Overview; Installing The Xyzrobot Servo Tool - XYZ Robot A1-16 Manual Del Usuario

02

Installing Servo Tool

Overview

The XYZrobot Servo Tool is designed specifically to configure an ID for a new servo.
Prior to installation, you will need to have the Adruino software and the Bolide driver code installed on
your computer system and the Bolide board, respectively.
See the following section for step-by-step instructions on installing the XYZrobot Servo Tool software.

Installing the XYZrobot Servo Tool

Before installing the Tool, download the driver from http:\\www.xyzrobot.com.
1.
Locate the downloaded driver file.
2. Click setup.exe to run the application.
The Launching Application window displays. Follow the on-screen prompts to continue.
NOTE: At the time of writing, the file and folder names were under development. File and folder
names may differ after production.
3. Click Install to install the XYZrobot Servo Tool.

Setting Up the Servo Tool