Installing The Motor Editor Driver - XYZ Robot A1-16 Manual Del Usuario

01

Installing the Motor Editor Driver

The following instructions guide you through the complete installation of the driver required for the
Servo Tool.
1. In Windows, go to Control Panel then to Device Manager to make sure the USB cable is
connected.
2.
Locate the driver and navigate to the following folder:
XYZ_Motor_Editor_Driver_v3 (For the latest software visit http://www.xyzrobot.com)
3. Click XYZ_Motor_Editor_Driver.ino to run the application.
4. From the menu toolbar, click Tools > Board and select the option XYZrobot-BOLIDE option.
5. Next, select the COM port associated with the Bolide Y-01. From the menu toolbar, click Tools >
Serial Port and select the associated option.
NOTE: If the device is not detected, the USB driver may not be recognized. The option to select
the associated COM port will not be available. You will need to update or re-install the
serial port drivers; see "USB Drivers" on the Bolide Y-01 User Manual.
6. Click (Verify) to compile the codes.
After compiling, the message Done compiling displays on the bottom of the frame.
If there are no errors and the compiling is complete, upload the code to the MCU board.
Setting Up the Environment