Operating The System Using The Myjablotron Smartphone App; Operating The System Via The Myjablotron Web Interface; Operating The System Using The Voice Menu; Operating The System Using Sms Commands - jablotron JA-103K Manual Del Usuario

2.2.1. OPERATING THE SYSTEM USING THE MyJABLOTRON
SMARTPHONE APP
Once a user account is created, the user can remotely monitor and control the system via
the MyJABLOTRON app for Android and iOS smartphones.

2.2.2. OPERATING THE SYSTEM VIA THE MyJABLOTRON WEB INTERFACE

The JABLOTRON 100 + system can be easily and conveniently operated using your computer via the
internet and the MyJABLOTRON web interface, which is accessible from www.myjablotron.com.

2.2.3. OPERATING THE SYSTEM USING THE VOICE MENU

The system can be controlled from a phone through a voice menu, which guides the user through a
series of options in the preconfi gured language. To access the voice menu, you just
dial the alarm system's phone number.
Access to the voice menu can be enabled either to all telephone numbers
without restrictions or alternatively only to authorized phone numbers stored in
the control panel. Depending on the confi guration, authorization by entering
a valid code on a phone keypad may be required. When the user enters
the menu, the system will give an update of the current status of all sections
assigned to the user. The caller then can control these sections, either individu-
ally or collectively, using phone keypad and available menu options.
The system default is set up to answer incoming calls after three rings (approximately 15 seconds).

2.2.4. OPERATING THE SYSTEM USING SMS COMMANDS

SMS commands can control individual sections and programmable outputs just
like keypad segment buttons. The form of text message to operate the system
is: CODE_COMMAND. The actual commands are predefi ned (SET/UNSET)
with an additional numeric parameter which identifi es a specifi c section. One
SMS can control multiple sections at the same time. In this case, added num-
bers in the command defi ne sections.
Example of an SMS command used to set sections 2 and 4.
CODE_SET_2_4
The commands to control the programmable outputs can be programmed by a system installer. For
example, you may choose BLINDS DOWN as your command to close the blinds on your windows.
It is also possible to confi gure the system not to require a code before a command. In such case the
command is simply automatically identifi ed when the system recognizes the user's phone number from
which the SMS was sent. Confi guration is done by a service technician.
2.2.5. OPERATING THE SYSTEM REMOTELY USING A COMPUTER
(J-LINK)
The JABLOTRON 100 + system can be operated remotely using a computer with an installed J-Link
software. It can be downloaded from the
2.2.6. CONTROLLING THE PROGRAMMABLE OUTPUTS (PG)

2.2.6.1. KEYPAD SEGMENT

A PG output switches on by pressing the right button of the segment and switches off by pressing the
left button. If the output is confi gured as a pulse output, it is switched off according to the pre-set time.
PG control may or may not be stored in the control panel's event memory. Confi guration is done by a
service technician.
Authorization is/is not demanded based on the system confi guration.
www.myjablotron.com website.
EN
39