Machine Maintenance; Lubrication - Enerpac QuickFace FF-120 Hoja De Instrucciones

Model FF-120
11. If the surface meets the desired results, remove
the machine by turning the mandrel locking knob
counterclockwise (see Figure 15). If the surface
needs to be cut again, repeat steps 4 – 11 until
complete.
Figure 15
1 - Lightly tap on top
of knob to loosen
locators from work
place.
12. With one hand, support the bottom of the
QuickFace housing. With the other hand, use a
soft mallet (provided with the machine) to lightly
tap on the top of the mandrel locking knob. The
QuickFace should now break free from the work
piece ID. If it does not break free, turn the mandrel
locking knob a few more revolutions and try lightly
tapping again.
13. Place the QuickFace back in its carrying case.
Remove the tool bit and the locators and place
them in their storage locations.
L3076 Rev.C
2
1
2 - Loosen mandrel
locking knob.

Machine Maintenance

Lubrication

The QuickFace is relatively maintenance-free; however
periodic lubrication is recommended to maximize
performance and longevity.
The mandrel parts should be periodically lubricated
with multipurpose bearing grease (see Figure 16).
Remove the locators and pull up on the mandrel
locking nut to pull out the expanding shaft. Unscrew
the mandrel locking nut and apply grease to the
surfaces shown.
1
3
Figure 16
1 - Mandrel Locking Nut
2 - Expanding Shaft
QuickFace Flange Facer
2
3 - Apply light coat of
grease here.
11