Introduction; General Description; Components; Mandrel Assembly - Enerpac QuickFace FF-120 Hoja De Instrucciones

QuickFace Flange Facer

Introduction

General Description

The Enerpac QuickFace
flange facer designed
flanges. The QuickFace
15 lb (6.8 kg) and is manually driven. The QuickFace has
2.8 in. (71.1 mm) of travel, mounts in diameters from
0.96 – 6.21 in. (24.4 – 157.7 mm), and faces diameters
from 0.96 – 12.0 in. (24.4 – 304.8 mm). Figure 1 shows
the clearance required to operate the QuickFace.
Swing Diameter = 20 in. (508 mm)
Figure 1

Components

Mandrel Assembly

The mandrel assembly consists of all the parts used
to secure the QuickFace in the work piece. Adjustable
locators and stackable locator extensions are used to
secure the QuickFace in place. An O-ring is used to
secure the locators to the mandrel (see Figure 2).
4
is a portable
to face raised face
weighs only
Figure 2
1 - Adjustable Locator
The mandrel locking knob is used to tighten the
locators inside the work piece ID (see Figure 3). As
the locking knob is turned clockwise, it pulls on an
expanding shaft which forces the locators out, pushing
against the ID of the work piece.
1
8
7
Figure 3
1 - Feed Knob
2 - Depth Adjustment
Knob
3 - Mandrel Locking
Knob
Model FF-120
1
2
2 - Locator Extensions
3
2
6
5
4
4 - O-Ring
5 - Tool Bit
6 - Tool Block
7 - Swivel Slide
8 - Feed Screw
L3076 Rev. C