Dispensing Of Beverages - Coffee; General Information - Cimbali M2 Manual Del Usuario

English

3. Dispensing of beverages - Coffee

GENERAL INFORMATION

Place the cup (or cups) under dispenser (1) of the required
group.
Adjust the height of the dispenser (1) if necessary.
Press the coffee dispensing key relative to the selected dose.
The led of the selected key lights up and dispensing
commences.
Dispensing stops automatically.
Delivery of powdered coffee for machines without
automatic dosers
After having positioned the cup under the spout,open the
decaffeinated coffee panel (18) and measure out a dose of
powdered coffee into the tube and close the powdered coffee
panel (18). The leds relative to the keys programmed for one
cup located on the display panel (3) will blink. Also, keys in
second selection and special key (25) will blink alternatively
if programmed.
Press one of the keys associated to the ignited leds that
corresponds to the desired dose.
Delivery terminates automatically.
Coffee STOP function
Use "OK" key to stop coffee dispensing before the
programmed dose has been reached.
NOTE: use of the "OK" button will not modify the programmed
parameters.
Blocked keypad
During normal use of the machine, sometimes a key may
become mechanically blocked. If this happens and the key
remains blocked for more than 1 minute, this message will
appear on the display screen:
Note: All other keys except the one involved will function
normally.
To solve the problem, examine the keypad, identify the blocked
key that caused the message, and follow the steps needed
to remedy the situation.
18
3
SECTION REPETITION Function
This function can be activated in various ways:
1) Press any one of the selection keys and after about 3
seconds press the same key again for the number of
dispensed drinks required.
The number of dispensed drinks programmed is indicated
on the top left of the display. Press the "OK" key and keep
pressed for about 3 sec. to reset.
2) Setting the desired number at the repeats entry in the
beverage recipe (see CLIENT PROGRAMMING and
paragraphs referring to Key Menu).
NOTE: These functions are deactivated when error messages
and/or codes are displayed and the item "Program. block" is
set on "YES".
06 September
wednesday
***********************************
***********************************
44
2006
15:15:04
BLOCKED KEY
English
OK
25
1