Check Control Messages - Cimbali M2 Manual Del Usuario

English
6.

Check Control Messages

The check-control messages are divided into two groups:
1. Messages in explicit mode:they position on the last line at the bottom of the Display (5). They are cancelled on each new
2. Messages in code: these appear in the top right-hand corner with the following syntax:i: Exxx
When there are several errors, their representation is timed, passing in succession on the display.
For more details, please consult the technical manual at the "Configuration menu - Defect - Malfunctions".
MESSAGE POSSIBLE CAUSES: when the message is visualized
Machine cold 1. This message will appear on the display every time the
machine is turned on until the service boiler pressure falls
below the pre-set working pressure. When the service boiler
reaches the pre-set pressure, the message automatically
disappears.
2. Whether the service boiler cannot reach the set working
pressure because of a problem, this message will be
integrated with the message in code identifying the component
that caused that problem.
No coffee The right, left or both hoppers are almost empty.
(SX/DX) The message appears when the machine is provided with sensors
Grounds This message means that the coffee ground drawer is full.
drawer full 10 more coffee selections (or 5 double dose) may be made
(coffee-based drinks) before the machine is blocked and the
following message is then displayed.
Empy drawer The machine counts in decreasing order the pre-set
maximum grounds number. This message means that that
value run out. The machine is blocked and no coffees
beverages can be delivered.
Grounds This message always appears when the back side of the
drawer drawer is not in the right position.
removed
Boiler filling This message is displayed when the machine is filling the
boiler
Service This message is displayed when the machine requires the
needed periodic maintenance intervention. In order to eliminate
temporary the message, keep pressed RES key for
approximately 8 seconds. The message will reappears in the
successive relighting of the machine with the main switch.
cycle and then appear again if the cause that generated them returns
Messages in explicit mode
· E indicates an error;
· xxx rappresents the error code of the unit.
VERIFICATIONS
2. Consult the technical manual and refer to
the specific error code which will be flashed
on the display to solve the problem
Fill in the hopper with coffee beans.
Empty the drawer to reset the counter or
wait until when the machine will display the
message 'empty drawer'.
Consult the technical manual to program the
number of grounds to the attainment of which
the message will be visualized.
Remove the coffee grounds drawer.
Empty the drawer and replace it in the
correct position. Close the panel. During
this operation the message 'Groun. Draw.
Removed' will be displayed.
If this message appears when the drawer is
inserted, check the drawer is correctly
positioned.
This operation is performed automatically
and requires no action by the user.
This operation does not impede the hot
water delivery.
Contact the authorized technical
department. The message will be displayed
until the service will be carried out. (Refer to
the Technician's Manual).
52
where:
English