Dispensing Of Beverages - Hot Water / Steam; Autosteam - Cimbali M2 Manual Del Usuario

English

3.4 Dispensing of beverages - Hot water / steam

HOT WATER: GENERAL INSTRUCTIONS
Place the appropriate container under the hot water dispenser
(14)
Dispensing with automatic dosing
Press one of the hot water dispending keys (12)
corresponding to the desired dose.
The programmed dose of hot water will pour from the
dispenser (14) and will stop automatically.
N.B. Dispensing may be stopped by pressing the (12) key.
Pressing the (12) key does not change the parameters set
during the programming phase.
STEAM: GENERAL INSTRUCTIONS
Fully immerse the steam dispenser tube (15) into the vessel
containing the beverage that needs to be heated.
Dispensing through the tap (13)
Turn the steam tap knob.
Wait until the beverage has reached the required temperature.
Stop the steam dispenser by turning the knob of the steam
tap in the opposite direction.
Note: At the conclusion of each steam dispensing phase,
clean the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully activate
steam dispensing at least once.
Dispensing with the Autosteam selector (13) (when provided)
Machines equipped with the AUTOSTEAM (STOP STEAM)
dispensing system have the "stop steam dispensing when
set temperature is reached" function, and can rapidly heat
and froth milk.
Select the type of milk you desire:
- using the buttons 13a (frothed) or 13b (hot);
- using the knob, clockwise (hot) or counter-clockwise
(frothed).
When the set temperature is reached, steam dispensing
can be stopped:
- automatically;
- manually, pressing buttons 13a or 13b again, or turning the
knob in in any direction.
For more information on the function, please consult the
engineer's manual.
12
14
47
English
13
15
OK
13b
13a
15