Anomalies - Cimbali M2 Manual Del Usuario

English
MESSAGE POSSIBLE CAUSES: when the message is visualized
No milk The message is displayed only if the machine is connected
to a 'Fresh Milk' and indicates that there is no milk in the
refrigerator tank.
Softener This message is displayed when the softener resins need to
be regenerated. (Follow the instructions on softener
maintenance).
Machine in This message is displayed when the machine switch ON/
stand-by OFF has been programmed. The message indicates that the
machine is switch-off and is in stand-by status.
Messages
about
washings

7. Anomalies

Customer interventions
Before calling the servicing department, verify whether the problem encountered with the machine is described herebelow in
order to avoid unnecessary expenses:
ANOMALIES
The coffee machine does not
function and the display (5) is off.
Water leak in the cup-warmer tray
(16)
Coffee dispensing time too short.
Coffee drips out of machine.
Loss of water under the machine.
Machine heated up, but it does not
dispense coffee.
The automatic level control devices
remain in operation.
Messages in explicit mode
CAUSE
No electricity.
Clogged basin hole.
Coffee ground too coarse.
Coffee too old.
Coffee ground too fine.
Discharge well clogged up.
Clogged drainage basin
Water supply or water softener tap
closed. No water in system.
Same causes as above.
53
VERIFICATIONS
Re-fill in the refrigerator tank.
Once regeneration has been completed, keep
the RESET key pressed for
seconds to cancel out the message.
Refer to the Technician's Manual to see how
to program the switch ON/OFF of the
machine.
Press the "OK" key for a few seconds to force
the machine on.
Please consult this manual at the "Cleaning
operations ".
REMEDY
Check that the electricity is on.
Check the position of the main
switch (23).
Clean
Use a finer grind.
Use new coffee.
Use a coarser grind.
Clean.
Open.
Wait until water is available or call a
plumber.
Same solution as above.
English
approximately 8