Overload Cut-Out - AEG Electrolux KM 8 Assistent Serie Instrucciones Para El Uso

822_949_289 KM850_880.book Seite 24 Mittwoch, 23. Januar 2008 9:07 21
g

Overload cut-out

The appliance is equipped with an
overload cut-out, which switches the
appliance off if it starts to overheat,
protecting the unit from damage.
When this happens, the overload cut-
out reset button (Fig. 1/N) jumps out.
If this happens, proceed as follows.
1
Failure to follow this procedure can
result in damage to the appliance,
which is not covered by the guarantee.
0 Allow the appliance to cool down for
at least 15 seconds.
0 Turn the speed selector (Fig. 1/I) left to
"0" position (Fig. 16/①).
0 Remove the mix container or all-pur-
pose bowl (Fig. 16/✍ and ③), as descri-
bed at the relevant point in these
operating instructions.
0 Remove the mains plug from the
socket (Fig. 17/①).
0 Lay the appliance on its back to gain
access to the bottom (Fig. 17/✍).
0 Press the overload cut-out reset button
(Fig. 1/N) on the bottom of the appli-
ance. If the appliance has cooled down
sufficiently, the button will engage
(Fig. 17/③). If it jumps back out, allow
the appliance to cool down a little lon-
ger, then repeat the process.
0 Once the reset button has engaged,
put the appliance back to its normal
working position (Fig. 18/①).
0 Plug the power lead back into the
mains socket (Fig. 18/✍).
0 Replace the mix container or all-pur-
pose bowl (Fig. 18/③ and ④), as descri-
bed at the relevant point in these
operating instructions.
0 The appliance is now ready for use
again. Turn the speed selector to the
right to the required position (Fig.
18/⑤) and continue with the function
that was interrupted.
24
Mixer
The mixer is used to prepare a wide
range of mixed drinks, to crush ice,
reduce fruit and vegetables, etc.
Preparing mixer
In order to fit the mix container, the
safety cover for the mixer drive (figs.
1/T and 4) must be removed.
0 Turn the safety cover clockwise and
remove.
– The red warning lamp (fig. 4/a)
flashes.
0 Place the mix container (figs. 1/B and
2) on the mixer drive (arrow
arrow ) and turn counter-clock-
wise to the stop. The mix container is
heard to engage. The two black arrows
must coincide.
– The red warning lamp (fig. 4/a)
extinguishes.
0 Only KM 850: Place mixer cover (figs.
1/C and 3) on mix container and turn
until the nose of the cover is directly
above the handle. The cover can be
heard to engage.
3 The mixer can only be switched on
when the container and cover are fit-
ted correctly.
0 Only KM 880: Place mixer cover on
mix container.
3 The mixer can only be switched on
when the container is fitted correctly.
0 Fit closing cover (fig. 1/D) and lock.
Operating mixer
0 Open cover (fig. 1/C) and fill all ingre-
dients required in the container.
Caution: Do not exceed maximum fill-
ing volume of 1.5 litres!
3 During operation further ingredients
can be added through the filling inlet.
The sealing cover (fig. 1/D) can also be
used as a filling beaker for this pur-
pose. Close the filling inlet again
on